Each year component failure through inherent and non-inherent material defects causes such problems as environmental pollution, risks to the health and safety of personnel, damage to property and loss of production. The financial cost of this to a company can be enormous and in some extreme cases disastrous to the point of bankruptcy.

Early detection of material corrosion and defects must be of paramount importance to any company wishing to prevent any of the above outlined problems. Utilising state of the art eddyMax® Eddy Current computerised technology is our solution. This is an inspection technique that has been proven on projects within the oil, gas, chemical, power generation and other industries both onshore and offshore in Europe, the Middle East, Asia and North America.

The technical advantages of utilising Eddy Current technology are

	inspection of ferrous and non-ferrous metals
	non-invasive inspection
	remote controlled operation for inspection in high radiation areas
	remote controlled operation for inspection where the access is limited
	minimum pre-inspection cleaning preparation of the material surface
	fast inspection rate - subject to access
	high detection sensitivity
	fast data retrieval
	user friendly colour mapped reports

Documentation can be produced as per customer requirements.

Bolts - shaft and thread Drill Pipe - shaft and thread Rollers Shafts - Turbine, Pump, Generator, Motor, etc. Turbine Blades Impeller Blades Pipes Vessels Aircraft Parts Welds